SENSOR, Manifold Air Pressure (MAP): Removal: 6.1L

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Intake Manifold, MAP Sensor & Fitting

Courtesy of CHRYSLER LLC

The Manifold Absolute Pressure (MAP) sensor (2) is located at the rear of the intake manifold (1).

Fig 2: MAP Sensor, O-Ring Seal & Sensor Mounting Bolts

Courtesy of CHRYSLER LLC

Disconnect electrical connector at sensor.
Remove two sensor mounting bolts (3).
Check condition of sensor O-ring (2).