SENSOR, Manifold Air Pressure (MAP): Removal: 5.7L
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electrical Connector, Cowl/Hood Seal, Manifold Absolute Pressure (MAP) Sensor & Intake Manifold
The Manifold Absolute Pressure (MAP) sensor (3) is mounted into the top/rear of the intake manifold (4) near the cowl/hood seal (1).
- Disconnect electrical connector at sensor by sliding release lock out (1). Press down on lock tab (2) for removal.
- Rotate sensor 1/4 turn counter-clockwise for removal.
- Check condition of sensor o-ring.