SENSOR, Manifold Air Pressure (MAP): Removal: 3.5L

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: MAP Sensor Location

Courtesy of CHRYSLER LLC

Sensor location.
Disconnect negative battery cable.

Fig 2: MAP Sensor Electrical Connector Unlock
Courtesy of CHRYSLER LLC
Unlock the electrical connector.

Fig 3: MAP Sensor Electrical Connector
Courtesy of CHRYSLER LLC
Disconnect the electrical connector.

Fig 4: Rotating MAP Sensor 1/4 Turn Clockwise
Courtesy of CHRYSLER LLC
Rotate sensor 1/4 turn clockwise.
Pull up on sensor.

Fig 5: Removing/Installing MAP Sensor
Courtesy of CHRYSLER LLC
Remove sensor.