SENSOR, Manifold Air Pressure (MAP): Installation: 5.7L
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electrical Connector, Cowl/Hood Seal, Manifold Absolute Pressure (MAP) Sensor & Intake Manifold
- Clean MAP sensor mounting hole at intake manifold.
- Check MAP sensor o-ring seal for cuts or tears.
- Position sensor (3) into intake manifold.
- Rotate sensor 1/4 turn clockwise for installation.
- Connect electrical connector (2) to sensor (3).