SENSOR, Manifold Air Pressure (MAP): Installation: 3.5L

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: MAP Sensor O-Ring Seal & MAP Sensor Mounting Hole

Courtesy of CHRYSLER LLC

Clean MAP sensor mounting hole at intake manifold.
Check MAP sensor o-ring seal for cuts or tears.

Fig 2: Removing/Installing MAP Sensor
Courtesy of CHRYSLER LLC
Position sensor into intake manifold.

Fig 3: Rotating MAP Sensor 1/4 Turn Clockwise
Courtesy of CHRYSLER LLC
Rotate sensor 1/4 turn clockwise for installation.

Fig 4: MAP Sensor Electrical Connector
Courtesy of CHRYSLER LLC
Connect electrical connector to sensor.
Lock electrical connector.
Connect negative battery cable.