SENSOR, Air Temperature, Inlet: Removal: 6.1L

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cleaner Housing, Retaining Bolt, Makeup Air Hose & Intake Air Temperature Sensor

Courtesy of CHRYSLER LLC

The Inlet Manifold Air Temperature (IAT) sensor (4) is installed into the rubber air intake hose near front of throttle body.

Fig 2: IAT Sensor, Electrical Connector & Sensor Probe

Courtesy of CHRYSLER LLC

Pull sensor from rubber hose.
Disconnect electrical connector (1) from IAT sensor (2).
Check sensor probe (3) for damage.
Clean dirt from sensor base.