RAIL, Fuel: Installation: 3.5L
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Lightly lubricate the fuel injector O-rings with a couple drops of clean engine oil.
- Install retaining clips on fuel injectors.
- Push injectors into fuel injector rail until clips are in the correct position.
- Position fuel rail over cylinder heads, and push rail into place. Tighten fuel rail mounting bolts to 28 N.m (250 in. lbs.) torque.
- Connect the fuel supply tube quick connect fitting to the fuel rail. See Fuel System/Fuel Delivery/FITTING, Quick Connect - Standard Procedure .
- Connect the electrical connectors to the fuel injectors.
- Install intake manifold plenum. Refer to Engine/Manifolds/MANIFOLD, Intake - Installation .
- Connect negative cable to battery.
- Use the scan tool to pressurize the fuel system. Check for leaks.