If The Engine Was Not Started After Incorrect Or Contaminated Fuel Was Used During Refueling

If the fuel system has been contaminated with (gasoline, water, etc.) and the engine WAS NOT STARTED, the following procedure must be followed:

1. Remove all fuel from the fuel tank, perform the fuel tank draining procedure. See Fuel System/Fuel Delivery - Standard Procedure . Use an OSHA approved properly marked fuel container. Dispose of the contaminated fuel using the proper procedures.
   CAUTION: Dispose of petroleum based products in a manner consistent with all applicable Local, State, Federal, and Provincial regulations.
2. Remove the fuel tank. See Fuel System/Fuel Delivery/TANK, Fuel - Removal .
3. Ensure the swirl pot indentation below the in the fuel tank electric fuel pump inlet is completely drained of any contaminated fuel.
4. Completely drain the low pressure fuel lines and install a new fuel filter.
5. Install the fuel tank. See Fuel System/Fuel Delivery/TANK, Fuel - Installation .
6. Fill the fuel tank with clean diesel fuel.
7. Start the engine and check for leaks.
8. Road test the vehicle to verify normal operation.