LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 311 (Vehicle Theft Security System (Service Information)) >> SENSOR, Intrusion Module, Export >> Removal >> Transmitter

SENSOR, Intrusion Module, Export: Removal: Transmitter

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Bezel
GC0080258Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. If replacing the bezel, pull the bezel (1) inboard from the C-pillar (3), or use a trim stick or equivalent to unsnap it from the transducer housing (2) of the intrusion sensor transmitter.
  3. Remove the C-pillar trim panel. Refer to Body/Interior/PANEL, C-Pillar Trim - Removal .
  4. Remove the two retaining screws from the C-pillar and remove the sensor.
scientia non olet · About LEMON Manuals