LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 311 (Vehicle Theft Security System (Service Information)) >> SENSOR, Intrusion Module, Export >> Removal >> Receiver

SENSOR, Intrusion Module, Export: Removal: Receiver

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Intrusion Sensor Receiver
GC0080259Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the overhead console from the headliner. Refer to Electrical/Overhead Console - Removal .
  3. Disconnect the electrical connector (5) on the receiver housing.
  4. Release the three latch features (2) of the mounting bracket and disengage the receiver from the bracket.
scientia non olet · About LEMON Manuals