LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 311 (Vehicle Theft Security System (Service Information)) >> SENSOR, Intrusion Module, Export >> Installation >> Transmitter

SENSOR, Intrusion Module, Export: Installation: Transmitter

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Bezel
GC0080258Courtesy of CHRYSLER LLC
  1. Position the sensor on the inside of the C-pillar.
  2. Install the two retaining screws.
  3. Connect the electrical connector.
  4. Install the C-pillar. Refer to Body/Interior/PANEL, C-Pillar Trim - Installation .
  5. If installing the bezel, position the bezel (1) over the transducer housing (2) of the intrusion sensor transmitter and press it straight on until it snaps into place against the C-pillar (3).
  6. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals