To Set a Desired Speed:

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: ACC Set Example

Courtesy of CHRYSLER LLC

When the vehicle reaches the speed desired, push the lever down and release ("SET/DECEL"). The EVIC will display the set speed.

Fig 2: Driver Override Example

Courtesy of CHRYSLER LLC

Remove your foot from the accelerator pedal. If you do not, the vehicle may continue to accelerate beyond the set speed. If this occurs:

The message "DRIVER OVERRIDE" will display in the EVIC.
The system will not be controlling the distance between your vehicle and the vehicle ahead.
The vehicle speed will only be determined by the position of the accelerator pedal.