LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Lighting Systems - Exterior (Service Information)) >> Headlamp >> Removal >> High Intensity Discharge (Hid) Headlamps (If Equipped) - Low Beam >> Ballast Module

Ballast Module

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Headlamp Attaching Screws
GC0013429Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove the headlamp unit (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/HEADLAMP UNIT - REMOVAL) .
    Fig 2: Retaining Screws
    GC0016109Courtesy of DAIMLERCHRYSLER CORP.
  2. From the underside of the headlamp unit, remove the six retaining screws (1).
    Fig 3: Electrical Connectors
    GC0016106Courtesy of DAIMLERCHRYSLER CORP.
  3. Pull the ballast module out of headlamp unit.
  4. Disconnect the two electrical connectors (1 and 2).
    1. One of the connectors (1) will be a standard push tab to release connector.
    2. The second connector (2) has a lever that must be rotated away or down from the wire of the cable and connector.
  5. Separate ballast module from headlamp unit.
scientia non olet · About LEMON Manuals