Rear Wheel Drive (RWD)
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate negative battery cable.
- Raise and support vehicle.
- Remove three starter mounting bolts (1).
- Move starter motor (2) towards front of vehicle far enough for nose of starter to clear. Always support starter motor (2) during this process. Do not let starter motor hang from wire harness.
- Remove battery cable-to-solenoid nut.
- Remove solenoid wire from solenoid stud.
- Remove starter motor.