LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 305 (Starting System (Service Information)) >> Starter >> Removal >> 5.7L >> All Wheel Drive (AWD)

All Wheel Drive (AWD)

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate negative battery cable.
  2. Raise and support vehicle.

    3. The steering gear assembly must be partially lowered to gain access to starter. Do not disconnect any hydraulic hoses or remove any steering linkage. Proceed.

  3. Remove coupling bolt (pinch bolt) securing steering gear to steering column.
  4. Remove three steering gear mounting bolts and slightly lower gear. Temporarily support the steering gear.
  5. Remove steering gear heat-shield.
    Fig 1: Starter Motor & Starter Mounting Bolts
    GC0080049Courtesy of CHRYSLER LLC
  6. Remove two starter mounting bolts (2).
  7. Move starter motor (1) towards front of vehicle far enough for nose of starter to clear. Always support starter motor (1) during this process. Do not let starter motor hang from wire harness.
  8. Remove battery cable-to-solenoid nut.
  9. Remove solenoid wire from solenoid stud.
  10. Remove starter motor.
scientia non olet · About LEMON Manuals