LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 305 (Starting System (Service Information)) >> Starter >> Installation >> 6.1L

Section 305 (Starting System (Service Information)): Starter: Installation: 6.1L

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Starter Mounting Bolt & Starter Motor
GC0080048Courtesy of CHRYSLER LLC
  1. Position the starter (2) into the transmission but do not install bolts.
  2. Connect the solenoid wire to the starter motor (snaps on).
  3. Position the battery cable to the solenoid stud. Install the battery cable eyelet nut.

    Tighten to 11 N.m (8 Ft. Lbs.).

  4. Install the three mounting bolts (1).

    Tighten to 54 N.m (40 Ft. Lbs.).

    Fig 2: Removing/Installing Heat Shield
    GC0080050Courtesy of CHRYSLER LLC
  5. Position the heat shield (3) and install the two shield mounting nuts (2).
  6. Lower the vehicle.
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals