LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 305 (Starting System (Service Information)) >> Starter >> Installation >> 5.7L >> Rear Wheel Drive (RWD)

Rear Wheel Drive (RWD)

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Starter Mounting Bolt & Starter Motor
GC0080048Courtesy of CHRYSLER LLC
  1. Position starter (2) into transmission but do not install bolts.
  2. Connect solenoid wire to starter motor (snaps on).
  3. Position battery cable to solenoid stud. Install and tighten battery cable eyelet nut. Refer to Electrical/Battery System - Specifications . Do not allow starter motor to hang from wire harness.
  4. Install and tighten three mounting bolts (1). Refer to TORQUE  Specifications.
  5. Lower vehicle.
  6. Connect negative battery cable.
scientia non olet · About LEMON Manuals