Section 305 (Starting System (Service Information)): Starter: Installation: 3.5L

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Starter Assembly, Starter Motor Dust Shield, Starter Mounting Bolts & Electrical Harness Mounting Bracket

Courtesy of CHRYSLER LLC

NOTE: All Wheel Drive procedure shown. Rear Wheel Drive Similar.

Install starter motor dust shield (2).
Rotate and install starter assembly (1) to transmission.
Install starter mounting bolts (3), and electrical harness mounting bracket (4). Tighten bolts to 54 N.m (40 ft. lbs.).

Fig 2: Starter Solenoid Terminal, Solenoid Stud, Electrical Connector, Battery Cable & Battery Cable Nut
Courtesy of CHRYSLER LLC
Connect electrical connector (3) to starter solenoid terminal (1).

Install battery cable (4) and nut (5) to solenoid stud (2). Tighten nut to 11 N.m (97 in. lbs.).

Fig 3: Oxygen Sensor, Oxygen Sensor Connector, Ball Flange Nut & LH Catalytic Converter

Courtesy of CHRYSLER LLC

1 - OXYGEN SENSOR

2 - OXYGEN SENSOR CONNECTOR

3 - BALL FLANGE NUT

4 - LH CATALYTIC CONVERTER

Install left side catalytic converter (4). Refer to Exhaust System/CONVERTER, Catalytic - Installation .
Connect negative battery cable, tighten nut to 5 N.m (45 in. lbs.).