Control Circuit Testing
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
The starter control circuit components should be tested in the order in which they are listed, as follows:
- Starter Relay - The starter relay is located within the TIPM (Totally Integrated Power Module). Refer to Non-DTC Diagnostics/Driveability - Gas - Diagnosis and Testing .
- Starter Solenoid - Refer to Diagnosis and Testing .
- Ignition Switch - Refer to Ignition Switch and Key Lock Cylinder
- Clutch Pedal Position Switch - If equipped with manual transmission, refer to Clutch Pedal Position Switch.
- Park/Neutral Position Switch - If equipped with automatic transmission, refer to appropriate Transmission SERVICE INFORMATION article.
- Wire harnesses and connections - Refer to the appropriate SYSTEM WIRING DIAGRAMS information.