Standard Starting System: Inspection
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
For complete starter wiring circuit diagrams, refer to appropriate SYSTEM WIRING DIAGRAMS. Before removing any unit from starting system for repair or diagnosis, perform the following inspections:
WARNING:
On vehicles equipped with airbags, refer to appropriate RESTRAINT SYSTEM article, before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.
- Battery - Visually inspect battery for indications of physical damage and loose or corroded cable connections. Determine state-of-charge and cranking capacity of battery. Charge or replace battery if required. Refer to BATTERY . Note: If equipped with diesel engine, a dual battery system may be used, and both batteries must be inspected.
- Ignition Switch - Visually inspect ignition switch for indications of physical damage and loose or corroded wire harness connections. Refer to Ignition Switch and Key Lock Cylinder.
- Clutch Pedal Position Switch - If equipped with manual transmission, visually inspect clutch pedal position switch for indications of physical damage and loose or corroded wire harness connections. Refer to Clutch Pedal Position Switch.
- Park/Neutral Position Switch - If equipped with automatic transmission, visually inspect park/neutral position switch for indications of physical damage and loose or corroded wire harness connections. Refer to appropriate Transmission SERVICE INFORMATION article.
- Starter Relay - The starter relay is located within the TIPM (Totally Integrated Power Module). Refer to Non-DTC Diagnostics/Driveability - Gas - Diagnosis and Testing .
- Starter Motor - Visually inspect starter motor for indications of physical damage and loose or corroded wire harness connections.
- Starter Solenoid - Visually inspect starter solenoid for indications of physical damage and loose or corroded wire harness connections.
- Wiring - Visually inspect wire harnesses for damage. Repair or replace any faulty wiring, as required. Refer to the appropriate SYSTEM WIRING DIAGRAMS information.