HOSE, Power Steering, Supply: Removal: Removal

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: BATTERY AND CABLES

Courtesy of CHRYSLER LLC

Disconnect and isolate battery negative cable (2) from battery post.
Siphon power steering fluid from pump reservoir.
Remove air cleaner housing and inlet tube to throttle body. Refer to Engine/Air Intake System/BODY, Air Cleaner - Removal

Fig 2: SUPPLY HOSE 3.5L
Courtesy of CHRYSLER LLC
2.7L/3.5L Engines - Remove hose clamp (2), then supply hose (3) from pump (1).

Fig 3: SUPPLY HOSE - 5.7L
Courtesy of CHRYSLER LLC
5.7L/6.1L Engines - Remove hose clamp, then supply hose (3) from pump (1).

Fig 4: SUPPLY HOSE - 3.0L DIESEL
Courtesy of CHRYSLER LLC
3.0L Diesel Engine - Remove hose clamp (2), then supply hose (3) from pump (1).

Fig 5: REMOTE RESERVOIR
Courtesy of CHRYSLER LLC
Remove hose clamp, then supply hose (3) at reservoir (2).
Remove supply hose from vehicle.