HOSE, Power Steering, Pressure: Removal: Right-Hand-Drive

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: BATTERY AND CABLES

Courtesy of CHRYSLER LLC

Disconnect and isolate battery negative cable (2) from battery post.
Siphon power steering fluid from pump reservoir.
Remove air cleaner housing and inlet tube to throttle body. Refer to Engine/Air Intake System/BODY, Air Cleaner - Removal

Fig 2: PRESSURE HOSE AT PUMP - 3.5L
Courtesy of CHRYSLER LLC
2.7L/3.5L Engines - Unthread tube nut, then remove pressure hose (2) from pump (1).

Fig 3: PRESSURE HOSE AT PUMP - 5.7L
Courtesy of CHRYSLER LLC
5.7L/6.1L Engines - Unthread tube nut, then remove pressure hose (2) from pump (1).

Fig 4: PRESSURE HOSE AT PUMP - 3.0L DIESEL
Courtesy of CHRYSLER LLC
3.0L Diesel Engine - Unthread tube nut, then remove pressure hose (2) from pump (1).
Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure
Remove belly pan. Refer to Frame and Bumpers/Under Body Protection/BELLY PAN - Removal

Fig 5: POWER STEERING HOSE ROUTING - RHD
Courtesy of CHRYSLER LLC
Remove screws (2) securing pressure hose (1) routing clamp to engine cradle.
Remove screw (7) securing pressure hose (1) routing clamp to engine cradle.
Unthread pressure hose tube nut (5) from steering gear.
Remove pressure hose (1) from vehicle.