LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 297 (Lighting Systems - Exterior (Service Information)) >> LAMP, Spot >> Removal >> Bulb

LAMP, Spot: Removal: Bulb

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: SPOT LAMP RETAINING SCREWS - REMOVE/INSTALL
GC0095274Courtesy of CHRYSLER LLC
  1. Remove the PDC cover and pull the fuse, depending on which spot lamp is being serviced.
  2. Raise the spot lamp from the stowed to the operating position.
  3. Support the spot lamp sealed beam in position.
  4. Remove the screws (1) retaining the bezel to the spot lamp head assembly.
  5. Remove the bezel from the spot lamp head assembly.
  6. Tilt the sealed beam (2) away from the spot lamp head assembly.
  7. Disconnect the electrical connector to the spot lamp head assembly.
  8. Remove the bulb from the lamp housing by moving the hold downs.
  9. Remove bulb from lamp.
scientia non olet · About LEMON Manuals