SENSOR, Wheel Speed, Front: Removal: All-Wheel-Drive

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure .

Fig 1: WHEEL SPEED SENSOR AT BODY - AWD
Courtesy of CHRYSLER LLC
Remove sensor cable routing clip (2) from brake hose bracket (3).

Fig 2: RELEASE WHEEL SPEED SENSOR CONNECTOR
Courtesy of CHRYSLER LLC

NOTE: To release sensor connector from body wiring harness connector (1) in following step, move retaining clip (2) as indicated here, then pull sensor connector (3) outward.

Fig 3: WHEEL SPEED SENSOR AT BODY - AWD
Courtesy of CHRYSLER LLC
Remove sensor connector (1) from body wiring harness connector (4).

Fig 4: WHEEL SPEED SENSOR AT FRONT KNUCKLE - AWD
Courtesy of CHRYSLER LLC
Remove screw (1) fastening wheel speed sensor (2) to knuckle (4). Pull sensor head out of knuckle.
Remove wheel speed sensor cable routing clip (3) from knuckle (4).
Remove wheel speed sensor (2).