VALVE, Positive Crankcase Ventilation (PCV): Removal: 5.7L

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: PCV Valve Mounted Into Top/Right Side Of Intake Manifold

Courtesy of CHRYSLER LLC

The PCV valve (3) is mounted into the top/right side of the intake manifold (2).

Fig 2: PCV Valve, O-Rings & Tabs

Courtesy of CHRYSLER LLC

The PCV valve (1) is sealed to the intake manifold with two O-rings (2).
Remove PCV valve by rotating counter-clockwise 90 degrees until locating tabs (3) have been freed. After tabs have cleared, pull valve straight up from intake manifold.
After valve is removed, check condition of two valve O-rings (2).