Throttle Body: Removal: 5.7L

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Throttle Body - 5.7L

Courtesy of DAIMLERCHRYSLER CORP.

CAUTION: Do not use spray (carb) cleaners on any part of the throttle body. Do not apply silicone lubricants to any part of the throttle body.

Remove rubber air duct at front of throttle body.
Disconnect electrical connector (3) at throttle body (1).
Remove four throttle body mounting bolts (2).
Remove throttle body from intake manifold.

Fig 2: Locating Throttle Body O-Ring At Intake Manifold - 5.7L
Courtesy of DAIMLERCHRYSLER CORP.
Check condition of throttle body o-ring (2) at front of intake manifold (1).