Sensor-Manifold Absolute Pressure: Installation: 6.1L
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of DAIMLERCHRYSLER CORP.
- Clean MAP sensor mounting hole at rear of intake manifold.
- Check MAP sensor o-ring seal (2) for cuts or tears.
- Position sensor (1) into intake manifold.
- Install two sensor mounting bolts (3).
- Connect electrical connector to sensor.