Sensor-Crankshaft Position: Installation: 6.1L
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Clean out machined hole in engine block.
- Apply a small amount of engine oil to sensor o-ring.
- Install sensor (4) into engine block with a slight rocking and twisting action.CAUTION: Before tightening sensor mounting bolt (3) , be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result.
- Install mounting bolt (3) and tighten to 12 N.m (106 in. lbs.) torque.
- Connect electrical connector (2) to sensor.
- IF STARTER IS MOUNTED TO RIGHT SIDE OF ENGINE: Install starter motor.
- Lower vehicle.
- IF STARTER IS MOUNTED TO RIGHT SIDE OF ENGINE: Install negative battery cable.