Sensor-Crankshaft Position: Installation
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - HEAT SHIELD |
| 2 - CRANKSHAFT POSITION SENSOR |
- Clean the crankshaft sensor bore and install the sensor (2). See Fig 1. Tighten the bolt to 9 N.m (80 in. lbs.).
- Connect the engine harness connector.
- Install the heat shield (1). See Fig 1.
- Lower the vehicle.
- Connect the negative battery cable.