LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Fuel System) >> Fuel Delivery - Diesel >> Standard Procedure >> Bleeding Air From Fuel System

Bleeding Air From Fuel System

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: No sparks, open flames or smoking. Risk of poisoning from inhaling and swallowing fuel. Risk of injury to eyes and skin from contact with fuel. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing.
  1. Turn the ignition off.
  2. Remove engine cover.
  3. Connect a hose to the fuel filter air bleed port and insert the remaining end into a approved and appropriately marked container.
  4. Turn the air bleed counterclockwise to open the air bleed.
    CAUTION: Turning the ignition to the on position will engage the in tank fuel pump. Be sure that the bleed hose and the fuel capture container is secure.
  5. Turn the ignition to the on position and observe the container until fuel flows free of bubbles.
  6. Turn the ignition off.
  7. Tighten the bleed valve on the fuel filter.
  8. Remove the bleed hose and container.
  9. Install engine cover.
scientia non olet · About LEMON Manuals