LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Fuel System) >> Fuel Delivery - Diesel >> Sensor-Water In Fuel >> Installation

Sensor-Water In Fuel: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Remove any dirt and debris around the fuel filter assembly using a suitable solvent or compressed air. Area around the fuel filter assembly must be clean and dry.
  1. Lubricate the water in fuel (WIF) sensor O rings with clean diesel fuel.
  2. Insert the WIF sensor into the fuel filter assembly and twist the sensor until the retaining holes align with the retaining bracket on the fuel filter assembly.
  3. Install the retaining screws. Tighten to 1.5 N.m (13 in. lbs.).
  4. Connect the WIF wiring harness connector.
  5. Connect the negative battery cable.
  6. Start the engine, allow to warm, turn engine off and inspect for leaks.
  7. Install engine cover.
scientia non olet · About LEMON Manuals