LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 288 (Electronic Control Modules (Service Information)) >> RECEIVER, Wireless Ignition Node >> Installation >> Floor Shifter

Floor Shifter

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The WIN initialization procedure is required whenever the WIN or shaft lock module is replaced on vehicles equipped with the shaft lock module. Refer to Electrical/Vehicle Theft Security - Standard Procedure and. See Electrical/Electronic Control Modules - Standard Procedure .
Fig 1: Wireless Ignition Node
GC0079985Courtesy of CHRYSLER LLC
  1. Reconnect the electrical connector (1) to the WIN and position the WIN back into the instrument panel.
    Fig 2: Wireless Ignition Node Screws
    GC0079984Courtesy of CHRYSLER LLC
  2. Install the four screws (1) through the instrument panel into the WIN.
  3. Install the instrument panel trim cover ensuring that the cover snaps into the securing clips.
    Fig 3: Lower Instrument Cluster Trim Screws
    GC0079982Courtesy of CHRYSLER LLC
  4. Install the two lower instrument panel screws (1).
  5. Install the lower steering column cover reinforcement and the steering column trim cover. Refer to Body/Instrument Panel/COVER, Steering Column Opening - Installation
  6. Connect the battery negative cable.
scientia non olet · About LEMON Manuals