LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (Engine Cooling System & Automatic Transmission Cooling System) >> Engine >> Thermostat >> Installation >> 3.5L Engine

3.5L Engine

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Lower Radiator Hose And Thermostat Housing
GC0095216Courtesy of CHRYSLER LLC
-
1 - THERMOSTAT
2 - RADIATOR HOSE
  1. Position gasket on thermostat and housing (1).
  2. Install thermostat housing (1), gasket and mounting bolts onto block. Tighten attaching bolts to 12 N.m (105 in. lbs.).
  3. Install radiator hose (2).
  4. Install air box assembly. Refer to Engine/Air Intake System/BODY, Air Cleaner - Installation
  5. Fill cooling system. See Cooling - Standard Procedure .
  6. Raise vehicle on hoist.
  7. Install belly pan. Refer to Frame and Bumpers/Under Body Protection/BELLY PAN - Installation
  8. Connect negative battery cable.
scientia non olet · About LEMON Manuals