SENSOR, Coolant Temperature: Removal: 5.7L/6.1L
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Partially drain the cooling system. See Cooling - Standard Procedure .
- Remove accessory drive belt. See Cooling/Accessory Drive/BELT, Serpentine - Removal .
- Carefully unbolt air conditioning compressor from front of engine. Do not disconnect any A/C hoses from compressor. Temporarily support compressor to gain access to ECT sensor (3).
- Disconnect electrical connector (2) from sensor (3).
- Remove sensor (3) from cylinder block.