LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (Engine Cooling System & Automatic Transmission Cooling System) >> Engine >> PUMP, Water >> Removal >> 5.7L/6.1L Engine

5.7L/6.1L Engine

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 5.7L/6.1L WATER PUMP
GC0095211Courtesy of CHRYSLER LLC
1 - WATER PUMP ASSEMBLY
2 - BOLT
3 - DOUBLE ENDED BOLT
  1. Disconnect negative battery cable.
  2. Drain cooling system. See Cooling - Standard Procedure .
  3. Remove radiator fan assembly. See Cooling/Engine/FAN, Cooling - Removal .
  4. Remove accessory drive belt. See Cooling/Accessory Drive/BELT, Serpentine - Removal 
  5. Remove thermostat. See Cooling/Engine/THERMOSTAT - Removal 
    NOTE: The water pump mounting bolts (2) are different lengths. Note the location of the water pump mounting bolts (2).
  6. Remove water pump mounting bolts (2) and remove water pump (1).
scientia non olet · About LEMON Manuals