LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (Engine Cooling System & Automatic Transmission Cooling System) >> Engine >> PUMP, Water >> Removal >> 3.0L Diesel

3.0L Diesel

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 3.0L WATER PUMP
GC0079914Courtesy of CHRYSLER LLC
WARNING: Risk of injury to skin and eyes from scalding with hot coolant. Risk of poisoning from swallowing coolant. Do not open cooling system unless coolant temperature is below 90°C (194°F). Open cap slowly to release pressure. Store coolant in suitable and appropriately marked container. Wear protective gloves, clothes and eye wear.
  1. Disconnect the negative battery cable.
  2. Remove the engine cover. Refer to Engine - Removal .
  3. Drain the engine coolant. See Cooling - Standard Procedure .
  4. Disconnect and remove the upper radiator coolant hose.
  5. Remove the accessory drive belt. See Cooling/Accessory Drive/BELT, Serpentine - Removal .
  6. Remove the EGR valve. Refer to Emissions Control/Exhaust Gas Recirculation/VALVE, Exhaust Gas Recirculation (EGR) - Removal .
  7. Remove the water pump and clean the sealing surfaces.
scientia non olet · About LEMON Manuals