LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (Engine Cooling System & Automatic Transmission Cooling System) >> Engine >> PUMP, Water >> Installation >> 5.7L/6.1L Engine

5.7L/6.1L Engine

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 5.7L/6.1L WATER PUMP
GC0095211Courtesy of CHRYSLER LLC
1 - WATER PUMP ASSEMBLY
2 - BOLT
3 - DOUBLE ENDED BOLT
  1. Install water pump and mounting bolts (2). Tighten mounting bolts to 28 N.m (20 ft. lbs.).
  2. Make sure double ended bolt (3) is in the proper location. Tighten double ended bolt to 28 N.m (20 ft. lbs.).
  3. Install thermostat. See Cooling/Engine/THERMOSTAT - Installation .
  4. Install accessory drive belt. See Cooling/Accessory Drive/BELT, Serpentine - Installation .
  5. Install the radiator fan assembly. See Cooling/Engine/FAN, Cooling - Installation .
  6. Connect negative battery cable.
  7. Evacuate air and fill cooling system. See Cooling/Engine/PUMP, Water - Standard Procedure 
  8. Check cooling system for leaks. See Cooling - Diagnosis and Testing 
scientia non olet · About LEMON Manuals