3.5L Engine
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - M8 FASTENERS (APPLY THREAD SEALANT) |
| 2 - M10 FASTENERS |
| 3 - M6 FASTENERS |
| 4 - M10 FASTENERS (STUD/NUT) |
- Clean all O-ring surfaces on front cover.
- Position water pump and O-ring to engine.
- Install mounting bolts (3). Tighten to 12 N.m (105 in. lbs.).
- Install timing belt. Refer to Engine/Valve Timing/BELT and SPROCKETS, Timing - Installation .
- Install accessory drive belts. See Cooling/Accessory Drive/BELT, Serpentine - Installation .
- Evacuate air and fill cooling system. See Cooling/Engine/PUMP, Water - Standard Procedure
- Check cooling system for leaks. See Cooling - Diagnosis and Testing