2.7L Engine
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - WATER PUMP |
| 2 - BOLTS |
| 3 - BOLTS |
- Clean all sealing surfaces.
- Install water pump (1) and gasket. Tighten mounting bolts to 12 N.m (105 in. lbs.).
- Install timing chain guides and timing chain. Refer to Engine/Valve Timing/CHAIN and SPROCKETS, Timing - Installation .
- Install the accessory drive belts. See Cooling/Accessory Drive/BELT, Serpentine - Installation .
- Install the radiator fan assembly. See Cooling/Engine/FAN, Cooling - Installation .
- Evacuate air and fill cooling system. See Cooling/Engine/PUMP, Water - Standard Procedure
- Check cooling system for leaks. See Cooling - Diagnosis and Testing