LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (Engine Cooling System & Automatic Transmission Cooling System) >> Accessory Drive >> BELT, Serpentine >> Removal >> 3.0L Diesel

3.0L Diesel

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Mixing Chamber
GC0085500Courtesy of CHRYSLER LLC
  1. Disconnect the negative battery cable.
  2. Remove the engine cover.
  3. Remove the intake air tube (4). Refer to Engine/Air Intake System/AIR CLEANER - Removal
  4. Remove the charge air inlet hose from the mixing chamber (1).
  5. Remove the mixing chamber (1).
    Fig 2: Identifying Belt 3.0L Diesel
    GC0079898Courtesy of CHRYSLER LLC
    CAUTION: Do not let tensioner arm snap back to the freearm position, severe damage may occur to the tensioner.
  6. Using a 12 point, 17mm socket and a long handle ratchet (3/8" drive), rotate accessory drive belt tensioner (5) counterclockwise until it contacts its stop.
  7. Remove accessory drive belt (3).
  8. Slowly rotate the belt tensioner (5) back into it's freearm position.
scientia non olet · About LEMON Manuals