LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 285 (2.7L Engine (Service Information)) >> Manifolds >> MANIFOLD, Intake >> Removal >> Intake Manifold Upper

Intake Manifold Upper

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: AIR CLEANER HOUSING
GC0081582Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the throttle body air inlet hose and air cleaner housing assembly (3). See Engine/Air Intake System/BODY, Air Cleaner - Removal .
  3. Disconnect the electrical connectors from the Manifold Absolute Pressure (MAP) sensor and the Electronic Throttle Control (ETC).
  4. Disconnect the vapor purge hose, brake booster hose and Positive Crankcase Ventilation (PCV) hose.
    Fig 2: Manifold Support Brackets
    GC0081591Courtesy of CHRYSLER LLC
  5. Remove the manifold support brackets (1).
  6. Remove the upper EGR tube from the intake manifold, and the upper EGR tube from the EGR valve.
    Fig 3: Removing/Installing Intake Manifold Bolts
    GC0081659Courtesy of CHRYSLER LLC
  7. Remove the manifold attaching bolts.
    Fig 4: Manifold Support Brackets
    GC0081591Courtesy of CHRYSLER LLC
  8. Remove the upper manifold (2).
  9. Remove the foam insulator (3).
  10. Inspect manifold (2). See Engine/Manifolds/MANIFOLD, Intake - Inspection .
scientia non olet · About LEMON Manuals