LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 285 (2.7L Engine (Service Information)) >> Manifolds >> MANIFOLD, Exhaust >> Installation >> Right Exhaust Manifold

Right Exhaust Manifold

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: RIGHT EXHAUST MANIFOLD
GC0081660Courtesy of CHRYSLER LLC
  1. Install exhaust manifold gasket and manifold (4). Tighten bolts working from center outwards to 23 N.m (200 in. lbs.).
  2. Install exhaust pipe to manifold. Refer to Exhaust System/CONVERTER, Catalytic - Installation .
  3. Install lower heat shield (3) and upper heat shield (2).
  4. Install oxygen sensor (5) and connect electrical connector.
  5. Connect down stream oxygen sensor electrical connector.
  6. Lower vehicle.
  7. Install EGR tube (1) using new gaskets. Tighten screws to 11 N.m (95 in. lbs.).
    Fig 2: Locating Battery
    GC0081581Courtesy of CHRYSLER LLC
  8. Connect negative battery (1) cable.
scientia non olet · About LEMON Manuals