LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (Ignition Control (Service Information)) >> Spark Plug >> Removal >> 3.5L

Spark Plug: Removal: 3.5L

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: IGNITION COILS
GC0080074Courtesy of CHRYSLER LLC
  1. Remove engine cover.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the intake manifold. Refer to Engine/Manifolds/MANIFOLD, Intake - Removal .
  4. Unlock and disconnect electrical connector (2) from ignition coils.
  5. Remove mounting bolts and engine cover studs (1).
  6. Twist, lift and remove ignition coil from engine.
    CAUTION: Prior to removing the spark plugs, use compressed air to remove any accumulated dirt and debris. If dirt and debris enter the engine, this may cause internal engine damage.
  7. Remove spark plug using a quality socket with a rubber or foam insert.
scientia non olet · About LEMON Manuals