LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 283 (Restraints System (Service Information)) >> AIR BAG, Passenger >> Installation >> Installation >> Deployed Passenger Airbag

Deployed Passenger Airbag

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Passenger Airbag Location
GC0080188Courtesy of CHRYSLER LLC
NOTE: For deployed passenger airbags, the instrument panel top pad must be replaced.
  1. Clean powder residue from interior of vehicle. See Restraints - Standard Procedure .
  2. Inspect and transfer all reusable components from the old instrument panel top pad to the new instrument panel top pad.
  3. Position new passenger airbag into instrument panel cavity.
    Fig 2: Passenger Airbag Fasteners
    GC0080189Courtesy of CHRYSLER LLC
  4. Install the two lower passenger airbag mounting bolts (2). Torque bolts to 11.6 N.m (103 in. lbs.).
  5. Install the four left and right passenger airbag mounting screws (1). Torque screws to 2.8 N.m (25 in. lbs.).
  6. Connect the passenger airbag electrical connector (3).
  7. Install new instrument panel assembly. Refer to Body/Instrument Panel/PANEL, Instrument - Installation .
    WARNING: Do not connect the battery negative cable. See Restraints - Diagnosis and Testing . Personal injury or death may result if the system test is not performed first.
scientia non olet · About LEMON Manuals