PAD, Heater: Removal: Removal
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The factory installed heating element can be removed from the foam cushions by carefully peeling the element off along the adhesive lines.
- Disconnect and isolate the battery negative cable.
- Remove the appropriate seat cushion. Refer to Body/Seats/COVER, Seat Cushion - Removal or seat back trim cover.
- Disconnect the inoperative heated seat cushion or seat back element electrical connectors (2).
- Remove the heating element by peeling it away from the foam, being careful not to remove excessive foam in the process.