LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Starting System) >> Starter Motor >> Removal >> Removal - 6.1L >> Rear Wheel Drive (RWD)

Rear Wheel Drive (RWD)

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate negative battery cable.
  2. Raise and support vehicle.
    Fig 1: Removing/Installing Heat Shield
    GC0040672Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove two heat shield nuts (2) and remove heat shield (3).
  4. Remove three starter mounting bolts (1).
  5. Move starter motor (2) towards front of vehicle far enough for nose of starter to clear. Always support starter motor (2) during this process. Do not let starter motor hang from wire harness.
  6. Remove battery cable-to-solenoid nut.
  7. Remove solenoid wire from solenoid stud.
  8. Remove starter motor.
    Fig 2: Removing And Installing Starter
    GC0015657Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals