Diagnostic Test

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

1) OTHER DTC'S
Ignition on, engine not running.

NOTE: This fault can be set if the wrong TPM sensor was installed on the vehicle, or that the wheel has a rubber valve stem. Check to make sure the vehicle is equipped with the correct sensors.

Use a TPM-RKE Analyzer tool 9936 to scan the spare tire pressure sensor, and make sure the Sensor 5 ID matches what is programmed into the WCM. The Sensor 5 Identification is located under "Data Display" for the "WCM Wireless Control Module". If the sensor 5 ID does not match, following the programming steps outlined in the diagnostic scan tool for "Program Tire Sensor ID w/TPM Tool" under "Miscellaneous Functions" for the "WCM/Wireless Control Module" menu item.

Drive the vehicle for a minimum of 10 minutes while maintaining a continuous speed above 15 mph (24 km/h).

With the scan tool, read DTC's.

Are any other DTC's present?

Yes
1. Repair all other DTC's first.
2. Perform *PCM VERIFICATION TEST .
No
1. With the scan tool, erase DTC's.
2. Perform TPM VERIFICATION .