Diagnostic Test
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR FCM CAN BUS DTCS
With the scan tool, read FCM DTCs.
Are there any FCM CAN BUS DTC's present?
Yes
- Refer to ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS article and perform the appropriate symptom.
- Perform NAG1 TRANSMISSION VERIFICATION TEST .
No
- Go To 2.
- CHECK IF ENGINE DTC'S ARE PRESENT
With the scan tool, read engine DTCs.
Are there any engine DTC's present?
Yes
- Refer to the appropriate Engine ELECTRICAL DIAGNOSTICS article and diagnose the appropriate symptom.
- Perform NAG1 TRANSMISSION VERIFICATION TEST .
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM per the Service Information. Refer to DESCRIPTION .
- Perform NAG1 TRANSMISSION VERIFICATION TEST .