LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Nag1 Automatic Transmission - Electrical Diagnostics) >> Nag1 - Electrical Diagnostics >> DTC Troubleshooting >> P0817-Starter Disable (P/N) Circuit/Open >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK IF TCM IS CORRECT 

    Flash and reprogram the TCM with the correct software per the Service Information.

    Perform NAG1 TRANSMISSION VERIFICATION TEST .

    Did the DTC reset after the Verification Test? 

    Yes 

    1. Using the schematics as a guide, check the Transmission Control Module (TCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM per the Service Information. Refer to MODULE-TRANSMISSION CONTROL .
    2. Perform NAG1 TRANSMISSION VERIFICATION TEST .

    No 

    1. Test Complete.
scientia non olet · About LEMON Manuals