LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 271 (Nag1 Automatic Transmission - Shifter Diagnostics) >> Nag1 - Shifter Diagnostics >> Standard Procedure >> Nag1 Transmission Verification Test >> Notes

Nag1 Transmission Verification Test: Notes

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

To validate that the repair(s) fixed the vehicle, perform the following steps.

  1. Reconnect any disconnected components.
  2. Connect the scan tool to the Data Link Connector.
  3. With the scan tool, erase ABS DTCs.
  4. With the scan tool, erase PCM DTCs.
  5. With the scan tool, erase TCM DTCs.
    CAUTION: Apply the parking brake.
    NOTE: The Transmission Temperature can only be read while in Reverse or Drive.
  6. With the scan tool, display the Transmission temperature. Start and run the engine until the Transmission temperature is above 43° C (110° F).
  7. If internal transmission components were repaired or replaced check the Transmission fluid and adjust if necessary. Refer to the Service Information for the proper Fluid Fill procedure. Refer to STANDARD PROCEDURE .
  8. If the TCM (EGS) is flashed or replaced, with the scan tool, perform an EGS initialization to relearn variant coding.
  9. If internal transmission repairs are performed or replacement of the Transmission Control Module, perform a TCM ADAPTATION procedure. Refer to STANDARD PROCEDURE .
  10. After performing the above procedures, perform the ROAD TEST PROCEDURE .
scientia non olet · About LEMON Manuals